10-05-2022, 08:51 PM
Goteks are normally set as drive 1 (not zero) if I recall correctly. This suits the standard IBM cable which sets the drive as A or B based on the position of the drive on the cable.
If you want to use the Gotek in a Microbee as A drive (drive 0) then your need to set the jumper to drive select 0. If it is still configured as drive 1 (B) and you have a drive B in the system as well, then
this may be the cause of your error message on the Gotek screen.
If you want to use the Gotek in a Microbee as A drive (drive 0) then your need to set the jumper to drive select 0. If it is still configured as drive 1 (B) and you have a drive B in the system as well, then
this may be the cause of your error message on the Gotek screen.