30-01-2026, 11:53 AM
Hi Glenn.
Yes, those caps from Jaycar look to be o.k. They only thing I was concerned about was the component height (which is specified as 25mm on the data sheet) but I think the height of the original
caps is around that anyway. Just thinking about the board to board spacing thats all.
Jaycar have a couple of bridge rectifiers that would suit, but I would choose this one :
https://www.jaycar.com.au/6a-400v-inline...r/p/ZR1360
You may have to form the leads a little to fit where the original bridges are, and be careful to check the polarity when you are installing both the bridges and caps.
Yes, those caps from Jaycar look to be o.k. They only thing I was concerned about was the component height (which is specified as 25mm on the data sheet) but I think the height of the original
caps is around that anyway. Just thinking about the board to board spacing thats all.
Jaycar have a couple of bridge rectifiers that would suit, but I would choose this one :
https://www.jaycar.com.au/6a-400v-inline...r/p/ZR1360
You may have to form the leads a little to fit where the original bridges are, and be careful to check the polarity when you are installing both the bridges and caps.