Well I managed to convert the Swedish boot disk image from .DSK to .IMD and write it on a single density double sided disk in my 360K floppy drive! So that part seemed to go well!
However when I insert the diskette in the leftmost diskdrive and start the Microbee up it turns on the LED and spins the disk but nothing happens!
So I have dismantled the disk unit again to go through the diskdrives and clean them up... as well as checking the drivebelts and lubricate the guiderails for the heads a bit!
Possibly also switch the two drive units out and set the rightmost drive as S0 and the other as S1 and try that instead!
However when I insert the diskette in the leftmost diskdrive and start the Microbee up it turns on the LED and spins the disk but nothing happens!
So I have dismantled the disk unit again to go through the diskdrives and clean them up... as well as checking the drivebelts and lubricate the guiderails for the heads a bit!
Possibly also switch the two drive units out and set the rightmost drive as S0 and the other as S1 and try that instead!